Effect of Al2O3 and CeO2 Nano-Additives on Performance and Emission Characteristics of Diesel Engine Fueled with Neem Oil-Biodiesel

Jump To References Section

Authors

  • Research Centre, Department of Mechanical Engineering, Ghousia College of Engineering, (Affiliated to Visvesvaraya Technological University, Belagavi), Ramanagara - 562159, Karnataka ,IN
  • Sampurna Institute of Technology and Research, (Affiliated to Visvesvaraya Technological University, Belagavi, Karnataka), Belekere, Channapatna - 562160, Karnataka ,IN
  • Maharaja Institute of Technology, (Affiliated to Visvesvaraya Technological University, Belagavi, Karnataka), Mysore - 571438, Karnataka ,IN

DOI:

https://doi.org/10.18311/jmmf/2022/31960

Keywords:

Al2O3 Nano-Additive, CeO2 Nano-Additive, CI Engine, Neem Biodiesel

Abstract

Due to the rapid depletion of petroleum reserves, many countries recommended the use of vegetable oils as diesel engine fuel. The best way to use edible and non-edible oil as a diesel fuel is to convert it into biodiesel. Biodiesel is a fuel which can be used instead of diesel fuel as an alternative for the existing system of CI engines. The usage of biodiesel causes a few disadvantages like high nitrogen oxides, utilization of high fuel and higher density. To conquer these problems some promising nano-additives are identified for having been used in the production of biodiesel. However, the addition of Nanoparticles will possibly enhance the performance and reduce the emissions. Therefore, the present investigation focuses on the influence of Al2O3 and CeO2 nano-additives on the performance and emissions characteristics of CI engine fueled with methyl esters of Neem. As nano-additives Al2O3 and CeO2 contain high oxygen content, it leads to complete combustion of fuel thereby increasing performance and reducing the oxide formation. In the experimentation, 50ppm, 100ppm of Al2O3 and CeO2 nano-additives were mixed in methyl esters of Neem. Subsequently, the fuel blends of Neem biodiesel (B20N) alone and Neem biodiesel with 50ppm, 100ppm of Al2O3 and CeO2 nano additives in CI engine were employed. The results revealed that, there is a increase in the break thermal efficiency and decrease in specific fuel consumption for B20N and B20N additive blends. Significant reductions in the parameters like CO, UBHC and NOx emissions are attained at B20N in conjunction with 50ppm, 100ppm of Al2O3 and CeO2 Nano-additives blends as compared with diesel. However, there is a slight increase in NOx emissions for B20N and and additive blends.

Downloads

Download data is not yet available.

Metrics

Metrics Loading ...

Downloads

Published

2022-11-25

How to Cite

R. Manjunatha, H. V. Byregowda, & G. Panduranga Murthy. (2022). Effect of Al<sub>2</sub>O<sub>3</sub> and CeO<sub>2</sub> Nano-Additives on Performance and Emission Characteristics of Diesel Engine Fueled with Neem Oil-Biodiesel. Journal of Mines, Metals and Fuels, 70(7), 364–369. https://doi.org/10.18311/jmmf/2022/31960

Issue

Section

Articles

 

References

Rutz D, Janssen R. Biofuel technology handbook. WIP Renewable energies; 2007. p. 95.

Demirbas A. Importance of biodiesel as transportation fuel. Energy policy 2007; 35(9):4661-70. https://doi.org/10.1016/j.enpol.2007.04.003 DOI: https://doi.org/10.1016/j.enpol.2007.04.003

Kaushik N, Biswas S. New generation bio-fuels technology and economic perspectives. Technology Information, Forecasting and Assessment Council (TIFAC), Department of Science and Technology (DST); 2010.

Ahmad M, Khan MA, Zafar M, Sulthan S. Environment-friendly renewable energy from sesame oil. Energy Sources. 2010; 32(2):189-96. https://doi.org/10.1080/15567030802467480 DOI: https://doi.org/10.1080/15567030802467480

Huang D, Zhou H, Lin L. Biodiesel: An alternative to conventional fuel. Energy Procedia. 2012; 16:1874-85. https://doi.org/10.1016/j.egypro.2012.01.287 DOI: https://doi.org/10.1016/j.egypro.2012.01.287

Kumar AR, Raju GJ, Reddy KH. Emission and performance characteristics of diesel engine using MameySapote biodiesel as alternate fuel. International Journal for Research in Applied Science and Engineering Technology. 2015; 3(7):289-98.

Vimal V, Shukla RP, Tushar MP, Radhashyam G. Performance and emission analysis of diesel engine fuelled with karnaja oil and diesel. International Journal of Advanced mechanical Engineering. 2017; 7(01):15-29.

Taymaz I, Coban M. Performance and emissions of an engine fuelled with a biodiesel fuel produced from animal fats. Thermal Science. 2013; 17:233-40. https://doi.org/10.2298/TSCI120602157T DOI: https://doi.org/10.2298/TSCI120602157T

Balaji G, Cheralathan M. Effect of CNT as additive with biodiesel on the performance and emission characteristics of a DI diesel engine. International Journal of Chem Tech Research. 2014-2015; 7:1230-6.

Wang J, et al.. Study on biodiesel heat transfer through self-temperature limit injector during vehicle cold start. Thermal Science. 2015; 19:1907-1918. https://doi.org/10.2298/TSCI141011177W DOI: https://doi.org/10.2298/TSCI141011177W

Adewale P, Dumont M-J, Ngadi M. Recent trends of biodiesel production from animal fat wastes and associated production techniques. Renewable and Sustainable Energy Reviews. 2015; 45:574-88. https://doi.org/10.1016/j.rser.2015.02.039 DOI: https://doi.org/10.1016/j.rser.2015.02.039

Abdoli MA, Mohamadi F, Ghobadian, Fayyazi E. Effective parameters on biodiesel production from feather fat oil as a cost-effective feedstock. International Journal of Environment. 2014; 8(1):139-48.

Altaie MA, Janius RB, Rashid U, Taufiq-Yap YH, Yunus R, Zakaria R, et al. Performance and exhaust emission characteristics of direct-injection diesel engine fueled with enriched biodiesel. Energy Convers Manage. 2015; 106:365- 72. https://doi.org/10.1016/j.enconman.2015.09.050 DOI: https://doi.org/10.1016/j.enconman.2015.09.050

Amber A, Fakhra A, Ammara S. Quantification of fat in chicken’s feather meal for its conversion into biodiesel. International Research Journal of Environment Sciences. 2014; 3(6):67-74.

Anurag KB, Akhilprasad, Anoop KV, Abinvarghese, Anvarsadath, Kalivarathan G. Experimental Investigation of blends of esterified coconut oil and sunflower oil in a 4 stroke CI engine. International Research Journal of Engineering and Technology. 2016; 3(2):1526-35.

Ashok B, Nanthagopal K, Subbarao R, Johny A, Mohan A. Experimental studies on the effect of metal oxide and antioxidant additives with Calophyllum Inophyllum methyl ester in compression ignition engine. Journal of Cleaner Production. 2017; 166:474-84. https://doi.org/10.1016/j. jclepro.2017.08.050 DOI: https://doi.org/10.1016/j.jclepro.2017.08.050

Attia AMA, Hassaneen AE. Influence of diesel fuel blended with biodiesel produced from waste cooking oil on diesel engine performance. Fuel. 2016; 167:316-28. https://doi.org/10.1016/j.fuel.2015.11.064 DOI: https://doi.org/10.1016/j.fuel.2015.11.064

Verma P, Sharma MP. Performance and emission characteristics of biodiesel fuelled diesel engines. International Journal of Renewable Energy Research. 2015; 5(1):245-50.

Vinuothan K, Sequeira PR, Veneeth R. Investigations on the performance and emission characteristics of CI engine using different blends of waste cooking oil methyl esterethanol- diesel oil. Energy and Power. 2016; 6(1A):28-32.

Yang C, He K, Xue Y, Li Y, Lin H, Sheng H. Factors affecting the cold flow properties of biodiesel: Fatty acid esters. Energy Sources, Part A: Recovery, Utilization, and Environmental Effects. 2018; 40(5):516-22. https://doi.org/10.1080/15567036.2016.1176091 DOI: https://doi.org/10.1080/15567036.2016.1176091