Design and Analysis of Hose Clamp

Jump To References Section

Authors

  • Ramesh Kumar S C
     School of Mechanical Engineering, REVA University, Bengaluru 560064, Karnataka ,IN
  • Sunil Kumar S Tembad
     School of Mechanical Engineering, REVA University, Bangaluru-560064, Karnataka ,IN
  • Vikhyath P
     School of Mechanical Engineering, REVA University, Bangaluru-560064, Karnataka ,IN
  • Vishal J P
     School of Mechanical Engineering, REVA University, Bangaluru-560064, Karnataka ,IN
  • Shaik Shashavali
     School of Mechanical Engineering, REVA University, Bangaluru-560064, Karnataka ,IN

DOI:

https://doi.org/10.18311/jmmf/2022/31055

Keywords:

Bending Stress, Section Band Clamp, Rigid Cylinder.

Abstract

A hose is attached to and sealed off of a fitting such a barb or nipple using a hose clamp, hose clip, or hose lock. This study examines the relationship between experimental results and theoretical models to analyse the bending stress in hose clamps. in the experiment, stiff cylinder was encircled by flat section band clamps, and strain and related displacement were measured. To steadily increase torque till failure, the clamp nut was tightened. The theoretical torque value and the torque obtained from FEM analysis are compared and further analyzed to prepare the hose clamp.

Downloads

Download data is not yet available.

Metrics

Metrics Loading ...

Downloads

Published

2023-03-15

How to Cite

S C, R. K., Tembad, S. K. S., P, V., J P, V., & Shashavali, S. (2023). Design and Analysis of Hose Clamp. Journal of Mines, Metals and Fuels, 70(10A), 81–83. https://doi.org/10.18311/jmmf/2022/31055

Issue

Volume 70, Issue 10A, October 2022

Section

Articles

License

Copyright (c) 2023 Journal of Mines, Metals and Fuels

Creative Commons License

This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.

Crossref
Scopus
Google Scholar
Europe PMC

 

References

S.C. Jain, P.K. Sharma and D. Vadodaria, “MacPherson Suspension System - A Review”, International Journal for Technological Research in Engineering, Vol. 1, No. 12, 2014.

Karl-Heinz Muhr, Karl Biecker and Leo Schnanbelt, “Side Load Springs as a Solution to Minimize Adverse Side Loads Acting on the MacPherson Strut”, SAE Technical Paper Series, 1994.

Mehdi Bakhshesh and Majid Bakhshesh, “Optimization of Steel Helical Spring by Composite Spring”, International Journal of Multidisciplinary Sciences and Engineering, Vol. 3, Issue No.6, pp.47-51, 2012.

J. Hastey, “Optimization on MacPherson Suspensions with a Spring”, SAE Technical paper series No. 970100, 1997. DOI: https://doi.org/10.4271/970100

M. Shimoseki, “The Helical Compression Spring with Fixed Ends”, Transactions of the Japan Society of Mechanical Engineer 45:901-909, 1979. DOI: https://doi.org/10.1299/kikaic.45.901