Santanu Das

Report on WELD-2022

Jump To References Section

Authors

Santanu Das
Secretary, ISEC ,IN

Abstract

No Abstract.

Downloads

Download data is not yet available.

Downloads

PDF ⁰

Published

2022-05-01

How to Cite

Das, S. (2022). Report on WELD-2022. Indian Science Cruiser, 36(3), 56–57. Retrieved from http://www.informaticsjournals.com/index.php/ISC/article/view/37393

Download Citation

Issue

Volume 36, Issue 3, May 2022

Section

Conference Report

Most read articles by the same author(s)

Manas Kumar Saha, Ritesh Hazra, Ajit Mondal, Santanu Das, On Corrosion Resistance Of Austenitic Stainless Steel Clad Layer on a Low Alloy Steel , Indian Science Cruiser: Volume 32, Issue 3, May 2018
Santanu Das, Weld Cladding, ATIG Welding and Wire Arc Additive Manufacturing: Some Emerging Areas of Welding Research , Indian Science Cruiser: Volume 37, Issue 3, May 2023
Soumojit Dasgupta, Satadru Banerjee, Hares Hasan, Santanu Das, Application of The Ahp For Optimization of Weld Strength of Al-8%Sic Composite Using Pctig Welding , Indian Science Cruiser: vol 36 , issue 4 ,2022
Firdous Ali Khan, Pritam Chatterjee, Sumit Mandi, Upendra Kumar Shaw, Santanu Das, Supriyo Banerjee, Estimation of Roughness of Machined Surface Using Artificial Neural Networks , Indian Science Cruiser: Volume 36, Issue 3, May 2022
Dipanwita Biswas, Amit Banerjee, Santanu Das, Prosenjit Das, An Investigation on Machinability during Turning Al-Mg2Si-Si Composite in Dry Condition , Indian Science Cruiser: Volume 36, Issue 3, May 2022
Santanu Das, Report on National Welding Seminar (NWS-2022) and 15th Weld India Exhibition held on 19-21 January 2023 at Chennai Trade Centre, Nandambakkam, Chennai , Indian Science Cruiser: Vol 37, No 1 (2023)
Ujjal Baidya, Sanjoy Das, Santanu Das, Evaluation of Linear Stability of Porous Hydrodynamic Journal Bearings under Micropolar Lubrication Condition , Indian Science Cruiser: Vol 37, No 1 (2023)
Santanu Das, Cutting Tool: Chronology of Its Development , Indian Science Cruiser: Volume 35, Issue 6, November 2021
Krishnendu Mondal, Anjan Kumar Adak, Santanu Das, Bijoy Mandal, Machinability Study on Hard AISI 4340 Steel with Carbide Cutting Tools , Indian Science Cruiser: Volume 35, Issue 6, November 2021
Tapas Bera, Sudip Santra, Santanu Das, Performance Measure of Resistance Spot Welding of Similar and Dissimilar Triple Thin Sheets by using AHP-ANN Hybrid Network , Indian Science Cruiser: Volume 36, Issue 2, March 2022

1 2 3 4 5 6 > >>